The Best Outdoor Solar Waterproof Column Light Wiring Installing outdoor solar lights is a great way to light up the outside of your home or garden. However, if its not done correctly, you could end up with a lighting disaster. Fortunately, wiring up solar lights isnt too difficult and with a few simple steps, you can get your outdoor lighting setup up and running. When it comes to wiring up outdoor solar column lights, the first step is to disconnect the power supply. This way, you wont be at risk of an electric shock while wiring. Next, lay out your cables, making sure that all the necessary components are connected. This includes the power source, the columns, and then the lights. Depending on the model, the power source can either be from the mains or from a solar panel. If its from the mains, make sure that the cables are safe, secure, and in good condition. When everything is ready, connect the power source to the cables. Be sure to double-check if the cable is safe, secure and the control panel is wired up correctly. If everything is good, wrap up the wires in the waterproof cover and secure with electrical tape. This will ensure that the wiring is protected from the rain and other elements. Finally, make sure the columns are grounded, to avoid electric shock risks. To do this, attach the ground wire to a suitable ground stake and all the metal/aluminum railings in the area. Make sure to use the right size of wires and make sure the connections are tight. By following these steps, you can ensure that your outdoor solar waterproof column lights are wired up correctly. This way, you can enjoy the illumination that you desire without worrying about safety issues.